Heights from sections
Read a storey height off a section, check it against the levels written there, and let every wall that uses it follow.
Wall areas need heights, and the heights are on the sections. Measure Height reads the height between two levels on a section and keeps it, by name, for the whole contract. Every measurement that uses it follows when it is measured again.
Measure a height
- 1Open the section and press Measure Height.
- 2Click a point on each level: the floor, then the ceiling (or the wall plate).
- 3The bar shows Measured (at the page's scale) and, when level figures are written at both points, Levels written with the height between them. If the two differ by more than 20 mm it warns: They differ: check the scale or the levels.
- 4Type the name, e.g. Ground floor: floor to ceiling.
- 5Press Use 2.85 m (levels) or Use 2.851 m (measured). The height is saved and Height List opens.
How it is read
- Measured: the vertical distance between your two clicks times the page's scale. Only the up-and-down distance counts, so the two clicks need not be one above the other.
- Levels: a figure is taken as a level only when it says so, with a sign (+3.000, -0.450, ±0.000) or a level word (FFL, SFL, FGL, NGL, TOS, TOB, SSL, RL, LEVEL, LVL, W/P, CEILING, CLG, FL), so a dimension in metres is never read as a level.
- The level of a click is the one written beside it, or at the end of the level line it is on. The height is the difference between the two.
Measured needs the page's scale; the levels do not, so a section without a scale can still give a height from its levels.
Use a height
In a length's or an area's settings, Height from section lists the contract's heights (it appears once there is one). Choose one: x Height / depth takes its value. Typed goes back to a height of your own; typing a figure in x Height / depth also cuts the link.
The height list
Height List shows each height with its value, how it was found (Measured at the scale, From the levels written, or Typed), the drawing and page it was read on, what was read, and how many measurements use it.
- Measure again: click the two levels again (on a revised section, say). Every measurement using it takes the new height, and their rows on the measurement sheets follow.
- The bin deletes a height only when nothing uses it. Give those measurements another height first.
Good to know
Heights belong to the contract, not to one drawing: a height read on the sections is offered on every plan of the contract, and kept on a revised drawing. A count has no height: a door's height is its size, typed in its own settings.
Something unclear? Ask us on WhatsApp: we answer the same day.